torque to stress a 3” stud to 428,400 lbs using a hex nut. With a 3” MTX Supernut, only 114 ft•lbs on each of the jackbolts is needed to produce the same bolt load. hereparison: Superbolt vs. Hydraulic Wrench Hydraulic wrench torque for standard Nut [lb•ft] 716 2,173 5,160 18,925 47,497 74,214 106,868 Supernut fastener torque charts . metric torque chart for hex head cap screws torque chart for stainless steel cap screws size 316 i n c h-18/8 i n c h-10.1 9.6 6-40 12.7 12.1 8-32 20.7 19.8 . guide for prevailing-torque lock nut assembly torques (cad and wax, grade b, c, The above chart shows how Superbolt tensioners remain easy to install, even on larger sizes, compared to standard hex nuts. Only hand tools are required to tighten any diameter stud / bolt. Torque curve for 310 MPa (45,000 psi) bolt stress Torque required for standard nut Torque Nm (lb•ft) Torque required for Superbolt multi-jackbolt tensioner

Fastener Torque Specs Torque is applied to the fastener in an effort to elastically deform the bolt shank. In the case of bolts and nuts, this elastic deformation between the bolt head and the nut is critical in order to create tension or clamping force to hold the joint together. Learn more about proper wheel torque specifications at here . Menu My Store: 8799 e frank lloyd wright blvd - scottsdale. Wheel Torque Chart. 4X2/ ALL / SUPER DUTY 1999 - 2016 165 ft-lbs F-350 DUALLY ALL CABS / SUPER DUTY 1999 - 2016 165 ft- SUPERBOLT NUT TORQUE – 193 Ft LBS ON INDIVIDUAL JACK BOLT SUPERBOLT Installation and Removal Procedure. Installation Read herepletely before you begin! Contact SUPERBOLT, INC. erection Commissioning bar Chart. Uploaded by. rjpatil19. Ics Flyer Www Engl. Uploaded by. Adel Suker.

Torque Specifi cation Chart The following torque values are to be used on all fasteners unless otherwise specifi ed. Lubricated refers to fasteners in the “As Received” condition, which is normally a light preservative oil coating on unplated fasteners and no oil coating on plated fasteners. Torque has been converted into ft/lbs by dividing the result of the formula by 12 All calculations are for Coarse Thread Series (UNC). Grade 2 calculations only cover fasteners 1 ⁄ 4 - 3 ⁄ 4 in diameter up to 6 long; for longer fasteners the torque is reduced significantly.